My
Automatied
X Y Z Table
by K4CHT
A photo of the table
The stepper controls.
This is a brand new project, still under development
I have been working off and on for twenty years.
text.
This is a test line and to check the space for the length of the line,
it should be however displayed.
text.
E over I times R = ohms law
text.
I use a 286 computer
text.
Here is the OLD version
This OLD version had bad times
The cabinet is homemade.
text.
The NEW
version Now the removed
The later project
The serial out pin
The bottom PCB PCB size is 2 inches wide and 6 inches height
Software info / user guide for Dancad3d
The latest software Download here
screen, use the SELECT
the enter home mode RELATIVE mode.
In this mode is zero'ed.
The menu:
To enter the menu / settings use the MENU button
when in menu, use SELECT this is also shown in
the display.
Here is all the menu points:
